Revolution Electronics Electric Fuel Pump Controller. Primes the pump on key-on and turns the pump off if the engine stops.

Revolution Electronics Electric Fuel Pump Controller. Primes the pump on key-on and turns the pump off if the engine stops.

Product Code: HSM39435
Availability: Pre-Order, Inquiry Price

US$32.49

- +

For Bulk Order, Get Better Price.

About this product

*Monitors the tach signal - as long as there is a tach signal present, the pump is allowed to operate. If the engine stops, so does the fuel pump. Works with both inductive (stock) and square-wave (aftermarket) tach signals. For vehicles without a tach, connect to the negative side of the coil.

*Turns on an electric fuel pump for 3 seconds on initial key-on. This primes the fuel system and tops off the carburetors fuel bowls.

*Controls an electric fuel pump when a classic car or truck is upgraded from a mechanical fuel pump.

*Includes an intermal self-resetting 7 amp fuse and 15 feet of 16 gauge wire to connect the fuel pump. Higher amperage pumps can be controlled by adding an external relay.

*For 12V vehicles. 2 by 1.5 by 1 inches. Fully potted. Made in USA.

Description

Designed to safely control an electric fuel pump when a classic vehicle is upgraded from a mechanical fuel pump to an electric fuel pump. Powers the pump for three seconds on initial power-on to fill the carburetor bowls. After those first three seconds, the pump will only run if there is a tach signal. If the tach signal stops, the pump shuts off. Includes an internal 7A self-resetting fuse, 15 feet of 16 gauge wire, and the necessary hardware for most installations.